Labels:text | diagram | plan | technical drawing | sketch | black and white OCR: 1.75 .812 -. 175 CLIP LEAD ASSEMBLY: .110 IF YOU MAKE THE CLIP LEAD ASSEMBLY YOURSELF, YOU WILL NEED TO GET A CLIP LEAD THAT IS APPROXIMATELY THE SIZE OF THE ONE IN THE PICTURE. .350 DIA. J -z YOU WILL ALSO NEED A WIRE THAT IS ABOUT 6 TO 7 INCHES IN LENGTH. STRIP THE END OF THE WIRE ABOUT 1/8 INCH AND THEN TIN THE END. FEED THE WIRE THROUGH THE HOLE IN THE CAP AS SHOWN IN THE PICTURE. NEXT SOLDER THE WIRE TO THE METAL TAB COMING FROM THE BODY OF THE CLIP .100 LEAD. ONCE THE WIRE IS SOLDERED TO THE TAB WRAP IT AROUND THE MIDDLE OF THE TAB JUST LIKE IT IS SHOWN IN THE PICTURE. THE REASON THE WIRE IS WRAPPED AROUND THE TAB IS SO THAT THE WIRE DOES NOT BREAK AWAY FROM THE TAB. NEXT, CAREFULLY SLIDE THE CAP BACK OVER THE TAB UNTIL IT IS FRIMLY SEATED IN PLACE. THE LAST STEP IS TO STRIP THE OTHER END OF THE WIRE ABOUT 1/8 INCH AND TIN IT JUST LIKE THE CAP FIRST SIDE. AT THIS POINT THE CLIP LEAD ASSEMBLY IS READY TO BE INSTALLED INTO THE BOARD. JUST FOLLOW THE INSTRUCTIONS IN THE TEXT FILE FOR THAT INSTALLATION. WIRE CLIP LEAD BODY 6.00 METAL TAB SOLDER HERE WIRE SOLDER THE WIRE TO THE TAB AS SHOWN ABOVE. THE THO MEG AGNUS PROJECT THEN WRAP THE WIRE AROUND THE MIDDLE OF THE TAB. WHEN YOU WRAP THE WIRE AROUND THE TAB, MAKE SURE THAT YOU ALSO WRAP AT LEAST ONE TURN WITH THE INSULATION. THIS WILL ACT DRAWN BY: TITLE: AS A STRAIN RELIEF. THE TWO MEG AGNUS PROJECT NEIL COITO CLIP LEAD ASSEMBLY DATE: 8-4-92 SHEET OF SCALE: NONE SIZE: C DRAWING: REVISION: 1 TTMAP58D_CLIP COPYRIGHT 1992-93 STRUCTURED APPLICATIONS & DESIGNS, INC.
(.png)
